![]() ![]() Moved throttle up/down the speed is varied and looks good. Motor sounds good, esc beeps 2 times when connected now (arms). I guess the 1st time I must have accidently pgmed "something".which am not sure. NOW, the motor is working fine( it was in reverse so I had to change in radio). I read the instructions for the esc again (with its bad english!) and other posts about escs, I wanted to try and pgm myself, so I connected again. Yes I have a Futaba transmitter and motor's twitching was synching with the beeping(the 1st attempt it wasnt steady and was numbered and varying) now I tried the 2nd time: Is there a latest link that explains these in general, Or can some one tell me what options I need to select (when I figure how to decipher those beeps!) for this setup?! I heard esc programming can be messy and there are several versions of the same TP ESCs.I didnt want to mess it up. ESC's instructions didnt make much sense as the english was messed up! I am tryin and researching what those options are (I have attached instructions ) Should I pick 5LIPO option for cell type and No.? What is meant by Brake set, timing mode and PWM settings? ![]() I did the bench test with my setup, the ESC started to beep a lot and motor didnt move just vibrates a bit. I made my own 5s1p a123 pack from devault.ĪND I know nothing about ESC programming! Converting a Rascal40 to EP.Using a Towerpro power mosfet Mac8 70A ESC (says "no power output to Receiver"-meaning no bec), Brushless Outrunner OK-C4250 (3520) ,KV 600 rpm/v ,Both from unitedhobbies. Does anyone have this same esc? (see pic below) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |